Conception et réalisation de capteurs de force, capteurs de couple , électronique de conditionnement
|
|
The supervision software allows link between the programmer-simulator module and your computer by USB link to ensure the PROG Tx / Rx protocol.
This module USB_PR-02 offers 2 different setup :
1 -simulator function with internal reference setup voltage in the range of 2,65 to 5,5Vsetup.
In this configuration, the sensor which can be a force , torque , pressure transducer must be connected to the USB_PR-02 module like shown on the picture.
Then, you can apply your reference external load : in daN, N.m ,bar and then by writing the gain and offset values you check the voltage output corresponding to the known nominal value external load.
When the set of strain gauge sensor and programmable amplifier operate at a voltage of 2.65V, this voltage makes it possible to work in stand-alone mode with a 3.0V or 3.3V battery.
2 -direct programming function, internal programming management (without sensor connection) when the gain and offset values to be programmed are known. Gain and offset memorization with non erasable storage values in the memory of the AMP_GP1 circuit.
  Simulation of the voltage output of the gauge bridge, gain and offset programming of the amplifier board, integration of a miniature amplifier in the sensor, wide bandwidth of the 10KHz circuit, high stability.
 |