Bridge strain gauge simulator : SIM-PDJ
The bridge strain gauge simulator reproduces the differential mode output voltages of the Wheatstone bridge. A wide adjustment range allows the simulation up to 50mV/V in sensivity output signal.
The use of the SIM-PDJ is very important in the calibration operation of measurement chain when there is a set up of amplifiers withs stepped gain operation on sithe without being able to load the sensor.
Set up of the differential output voltage : dip switches et potentiometer
Supply voltage : de 1.00Vdc à 10.00Vdc.
For simulation of the sensor, there is 6 ranges of sensitivity selection by DIP SWITCHES and potentiometer :
N°
|
Niveau/Level
|
1
|
0.5mV/V
|
2
|
1mV/V
|
3
|
2mV/V
|
4
|
5mV/V
|
5
|
10 mV/V
|
6
|
50mV/V
|
Precision : 0,025%
0g